Nordic design and quality

Rated 4.9/5 stars on TrustPilot

Easy and fast installation

Nordic design and quality

Colour samples

Akupanel | 240 Assembly Installation on wall with glue

How to install on wall with glue

You will need this:

To install the panels, you need the following:

  • A saw – either a circular saw or a regular handsaw if the panels need to be trimmed.
  • Possibly small screws of about 15mm for securing the slats when trimming the panels.
  • A glue dispenser
  • Glue tube (about ½ tube per panel)
  • Ruler / tape measure.
  • Pencil.

Step 1: Prepare the wall

Start by preparing the wall. Wipe the wall with a cloth and remove any screws, nails, and other obstructions so that the wall is completely even. Then you can measure and mark where the panels are to be mounted.


Step 2: Cutting the panels to height

Once you have measured your wall, you will know if your panels need to be cut to fit on your wall.

If you need to adjust the panel to height, you can cut the panel using a circular saw or a jigsaw (a normal saw).

Mark the cutting line on the panel with a pencil, so you can make a straight cut.

How to cut the panels

Remember to screw the slats in place after cutting

After cutting the panel, it’s a good idea to screw the ends of the slats back in place (through the felt and into the slats) using about 15mm long screws. Otherwise, the slats may hang loosely.

Repeat through each slat.

How to screw slats in place

Step 3: Installing the acoustic panels with glue

Start by cutting the top of a glue tube and inserting it into the glue dispenser. Then distribute the glue evenly on the felt on the back of a panel.

Now you are ready to install the panels. Place the panel against the wall on the marked area on the wall. Press the panel against the wall over the entire surface, so that the glue is well distributed and sticks. The glue can hold the panel on the wall after 20-30 seconds. Check if the panel is installed straight by using a spirit level along the way.

How to mount the panels

Step 4: Cutting the panels to width

When you reach the end of your wall, you may need to cut the panel to fit in width.

You can adjust the panels in width by cutting the felt with a knife.

Then glue the last part of the panel onto the wall.

How to cut the panels width

Now you are done


Are things not going as planned? We are here for you if you need help.

Send us an email

pm@woodupp.co.uk

Business hours

Monday to Friday: 8.30am-16.30pm
Saturday & Sunday CLOSED